Oh, sorry I didn't mean to comment just the solution for the bottom trap. Have no input regarding that detail.
I meant the whole solution.
To me it looks like too many part, motors, switches, mechanical complexity, six heaters, complex software and so on. To many points of failure.
Compare this to a Jobo-like solution that has one motor, one pump and one heater.
You wouldn't have to drain and fill during processing of course, like in the Jobo, but you still have to do it before and after processing if I understand correctly.
Also I don't understand how you rinse. I at least would like to do so under running water for at least 5 minutes.
Well, if you are into standing and semi standing this could have an edge perhaps.
Bookmarks