Hi,
Fed up with waiting for Schneider center-filter iiib to appear on the auction site. Would Schneider center-filter iiic work? Its 2-stops instead of 1.5-stops.
Thanks for your help,
Matthew
Hi,
Fed up with waiting for Schneider center-filter iiib to appear on the auction site. Would Schneider center-filter iiic work? Its 2-stops instead of 1.5-stops.
Thanks for your help,
Matthew
Matt, the 58 SAXL covers 110 degrees @ f/22. Rodenstock recommends 2 stop CFs for 110 degree lenses, Schneider recommends a 1.5 stop CF for the 58 SAXL. At 110 degrees the corners are down 3.2 stops from the center, so a 2 stop CF will cut the drop to 1 stop from center to corner, a 1.5 stop will cut it to 1.5 stops.
I refuse to be held responsible for this advice -- the blame, if any, belongs to Rodenstock -- but you should be able to use a CF IIIc on your 58 SAXL without the world ending.
I knew Dan would answer this.
I'm confused as to your statements about "graininess" and underexposure in the sky. Usually the sky has quite a bit more light naturally. Also, grain usually happens from overexposure on b&w materials. Perhaps you mean to say that your sky is grainy and the foreground is underexposed...?
I use grad nd and work well. I just shot some landscapes with my 75mm on 4x5 and have very noticeable fall off at the edges. On one image (slide) the center is about 3 stops brighter than the surrounding edges. You can even make out that it is more or less a circle. Happens on my bw as well. Have not used a CS, but I am getting one here soon to experiment with. If I were to meter to expose for the center of the image without a filter, my edges would be useless I think.
Anyway, a grad nd works really well if done right, I prefer the reverse grad nd.
Matt,
I use a Center Filter 3 with my 58mm Super Angulon XL. My understanding is the 3 and 3c are very similar, but I know Schneider would say otherwise. I have not noticed any major fall off when using negative film, I primarily used Kodak Ektar, FP4 and HP5.
When I got the filter a few years ago I did a test with some FP100c with and without the filter using camera movements to to show the edge of the image circle. The left photo is without the filter (I only have a bad iphone photo right now, but if you like I can upload a scanned one when I get back home this weekend).
You can see without the filter there is a large drop off, and it is reduced with the CF 3, but not completely. The horizon on the photo is straight through the center of the lens, with front rise to show the edge of the image circle while the lens is stopped down.
Also, here are links to a photos that shows the full frame with negative film:
http://https://www.nathanlambrecht.com/index/G0000qa.6.8Lcjz8/I0000o99uQXkougA There is a grad filter over the sky in this photo.
http://www.nathanlambrecht.com/index...000w1BBhXJGNCE
I hope this helps.
-Nathan
I use the same Centre Filter for all of my wide angle lenses.
It is only a 1.5 stop filter - but its close enough.
If you do the maths for light fall off at cos^4, none of the Centre Filters will compensate exactly for the light fall off on any lens - even if the CF is identified to match the lens by the manufacturer.
Centre Filters are almost as rare as hens teeth - so if you think you have something which will get you close - buy it and use it.
You can always keep an eye open for the recommended filter.
Martin
Bookmarks