Hello everyone! I just picked up a 5x7 2D as a restoration process - decent example with good bellows (light-tigh, with a little cosmetic wear that just needs a little bit of liquid electric tape), but I've run into a bit of a snag while disassembling it. For the life of me, I can't figure out how to get the rear standard apart, and while I've searched this forum and have found a ton of great advice on working with these cameras, I haven't found an answer for this one. I've removed the block that holds the bellows in place, but the pivot pins on the rear standard are rivets, and I can't figure out a way to get everything apart without cutting those rivets. Is there something here I'm missing, or was this thing just manufactured in a way that made disassembly extremely difficult without replacing parts to put it back together?