Mine are frequently very dark, too, and I’ve tested, exposed and developed using BTZS.
Tin Can
Over-exposed and over--developed. Also, the developer you are using will produce too much contrast for this film. I have used more than 500 sheets of it and never used D-76 stock. In fact, I don't use it stock with any film. diluting it,andmost developers, produces a wider range of values.
Rodinal 1 part to 100 part distilled water
68f 71/2 minutes, with normal agitation
or Ilford PQ and watch under red SAFE light
Tin Can
Make sure you use 10mm Rodinol per 8X10
NOT 1ml per 100ml in a Rotary
Tin Can
Hi, I had the same problem with my first X-ray film and learnt from my mistakes.
The unexposed parts of the film lack transparency and I resolved and in my case, it was caused by my safe light that wasn't safe and by some light coming from the bottom of the bathroom door.
All my photos also ended up being too dark and resolved the problem by developping the film un less than 4 mn.
After many months of struggle since I started to read this topic, I have finally taken a photo I am pleased with.
Thank you all for sharing your work and tips here, I would have certainly given up without your contributions.
4x5 X-ray film by T. Chabry, on Flickr
The photo was shot with a 4x5 Newton New-View camera with a Kodak Ektar 127mm lens & Agfa G Plus X-ray film.
The exposition was set at 100 ISO, f4.7, 1/200 s. and it was developed in Kodak HC-110 dilution B for 4 mn.
Bookmarks