I just got my lenses back from Carol Flutot and they look great. Each one has a timing sheet. Lower speeds seem great, highest speeds are a little off on some. But at least I know that now.
I want to mount all the lenses on Linhof Tech boards. I assume they just unscrew and screw back together with the lens board sandwiched in-between.
Is there anything more to it? Make sure you do this or make sure you never do that...
Any words of advice before I screw it up?
I have a Voigtlander Collinear Series II, No.6, f/6.3, 12 1/4", on an old ACME ILLEX shutter that is a tad larger than a Copal #3 predrilled hole. I tllk a 1/2 round file and evenly enlarged the hole a couple of mm's so that now it fits. I'll have to drill 4 holes and put in machine screws. It does not look that hard, but then I've never done it before. I assume I'll have to screw the lens together tightly and then mark where the holes will need to be drilled. Then assemble.
Do I need any kind of lock-tight? any kind of gasket? anything for light tight mounting?
Thanks, Bill
Bookmarks