Shen Hao FCL-810A In The House!!

[Jess C]

I only had an issue when needing to use just a little back tilt. You have to pull the lever out to get the back to tilt, but mine won't push back all the way in unless there is a lot of back tilt. With just a few degrees of back tilt I had an issue.

OK, I went back and gave mine just a "little" rear tilt and the stop just barely comes into contact when the film holder becomes seated but not until it drops into the seated position. I do not think it is enough to interfere with the film holder and keeping it light tight. I guess I will find out when I require just a little rear tilt, otherwise, I will have to grind mine just as you did.

[sergiofigliolia]

After a few years if not a decade of usage I wanted to know what your experience was.
I have also a special question regarding the front standard. Does it allow to operate independently on rise/fall and tilt?
My precise scenario is to release shift and have any tilt movement locked. Can it do it?