http://www.ttind.com/vacuumoverview.html
I came across this in my search for designs.
http://www.ttind.com/vacuumoverview.html
I came across this in my search for designs.
Vinny: thanks for pointing me to that video on vacuum easel construction. I emailed the guy last night and by this morning he had sent me a copy of the video. Seems pretty straightforward once the proper perforated steel is located.
Dan
If it's a factor on a horizontal easel you could turn off outer regions when not needed by a valve. Use a manifold to divide the the airflow proportionally by region, then turn off those regions not being used. Looks like Grainger has a good selection of perf steel.
Some of us have built vacuum easels. I drilled small holes in Masonite on a half inch grid, although others have used pegboard. Internal bracing kept the Masonite from compressing inward due to the vacuum. Guides along two sides permitted precise placement of the photo paper. An ordinary vacuum cleaner provided the suction. A steel top would have been nice for using magnetic guides, but would have been more difficult and expensive to work with.
That unit in the link you gave looks pretty slick. I can't quite wrap my head around how it works though. I wish I could see a bigger picture of the surface and figure out how it can hold a vacuum on small prints with the rest of the easel unmasked? It looks very simple but my simple mind can't figure it out.
Erik
I believe that if you have a vacuum pump with sufficient CFM that there is no need for a manifold or valves. The size of holes and calculations for CFM required would be a rather straightforward.
I'm with Donald. Big enough pump solves the problem; you need lots of CFM but not a lot of pressure; a scroll-blower would be perfect.
ex-Pic-A-Day (slowed after 2 years)
on flickr
Analogue Photo and Film FAQ (for APUG)
Open Source F/Stop Timer
Bookmarks