I need to scan lots of transparencies using my IQSMART2 (Creo). I use an old G5 with 10.3.9 version. It always has been worked very good, however I had to create tables for a two days ago and an error occurred during the process. Since this moment I can't select the suitable range of sharp because the software does not allow me to select any of the different sharps I have already configurated, or select them using the icon of sharp that displays in the tool bar. When it begins to scan I can heard a hard noise and after few seconds it displays a message: "BUTTING TARGET SEARCH FAILED. DEFAULT FOCUS WILL BE USED". So you must to accept and it scans horrible images very quickly because the sharp is very bad.
I have tried to re-install the application (2.3.1) -I have the original CD... but is not possible to read it!!!!!- and I have to reinstall and create tables using the tool that exists in the application on my computer. There is no way to finish well this process, when I am finishing the tables, on the 18 table... it displays the miss age "BUTTING TARGET... B00000), you accept, it continues... but you can't see any folder with the new tables.
Bookmarks