Hi folks,
I could really do with some expert advice.
I bought a lens recently and discovered the aperture lever had absolutely no resistance, you could blow it and it would move.
I sent it back to the shop from where I bought it for repair and it has been returned in under a week!
The aperture lever now has resistance but I decided to remove it from the lens board to see if it had been a proper job.
The problem is I still can't tell. What I can say is that there is still resistance when the lens is not attached to the lens board. And what disturbs me the most is the large amount of surplus grease between the aperture dial and the lens board. None of my other lenses have this but none have been seviced in my ownership.
Could someone please tell me if this looks like a quick fix rather than a proper permanent solution to the problem?
Best regards,
Marty
Bookmarks