Just got a CPA and try to test it using normal drum first. But my main intention is used it mainly for my 8x10 Expert Drum 3005. (I got a ATL 1500 and a Duolab for smaller one.)
This is the first time I have a lift. My old CPE does not have one. I found the lift work ok for normal drum but for expert drum, it seems you have to use the one inlet/outlet thing above the expert drum one. I took out the Lift apart but cannot figure out how to get this. It is obvious that you have to move one of the pipe to the inlet/outlet thing above, as well as move two white bit (to clip on the expert drum top cover, as the normal drum do?). But how?
Took some pictures and in particular, I ask a few question on this one:
http://www.flickr.com/photos/dennisn...7624342465539/
I dare not just to move something as breaking it is very expensive I think.
Any help would be much appreciated.
Bookmarks