Originally Posted by
David McNiven
If you're unfamiliar with the word "shim" try google or Wiki perhaps.
Various thicknesses available (from a couple of thou') in plastics, brass, stainless etc.
Laser cutting is easiest & is accurate but expensive unless you own one... another way is to clamp between 2 thicker sheets cut to profile & drilled for pins. Holes are used for registration. Then you can cut & trim without bending the shim.
Small blades can be cut from feeler blades - available in any car accessory shop.
Use a blind hole for riveting rather than a vise.
Bookmarks