I just got my new 110 XL today and have a question about mounting it to a Tech I II lens board. The lens didn't come with any spacer ring to go between lens and lens board, but does have a tiny little set screw protruding from the back of th e shutter which makes contact with the front of the board and allows clearance f or the apeture ring to turn freely. But that small set screw (about 2mm head) is the only point of contact in the front. cranking down on the retaining ring on the back side of the board does squeeze the board against the screw and hold the board parallel with the front element, but the connection is spongy and doesn't seem right. Can anyone tell me if this is normal?

Thanks for any reply,

-Michael