Alright so a few months back after a while of using a beseler motor base to spin my jobo 3005, I acquired a cpp2 processor with a CPE arm. Everything seemed to working really well, except for in some negs with smooth skies I get dark blotches in my prints....... this would mean uneven development to me. I make sure the unit is level, so it I assume it is not due to that. I have been using JOBO's recommended chemistry amounts though so as not to stress the motor in the processor..... their amounts seem really low. Anyhow, if anyone has any suggestions please let me know. Could it be the CPE2 arm maybe? Some people say it is the exact same arm as the others. Or is it too little chemistry? thanks in advance.
Jordan
Bookmarks