When I recently went to remove a quickload from the holder I pulled and out came the piece of film. It was interesting to see what is inside a quickload, but overexposed the film a bit. I managed to get the rest of the holder out, although I don't recall whether I got the metal strip at the bottom out or not. I didn't really recognize that it needed to come out.
I figured this was just an aberration, put my gear away and didn't think about it. Until two days ago, that is, when the same thing happened again. Now the metal strip from that one is definitely stuck inside the holder.
Any suggestions for fixing this? I thought I would try to locate a very small Phillips screwdriver to take out the little screws holding the holder together, open it up and see what is going on. I thought I'd check here for better ideas first, though.
Bookmarks