Hi Folks
Just started scanning 5x4 negs on my epson 2450 using Vuescan and Make Gray From Green. Most of my negs are pyro - Pyrocat HD or PMK. I have noticed that these scan a lot darker than negs that I have that were developed in ID11. I am assuming that this is due to the pyro staining? If I do not use the green channel option the scans are lighter on pyro negs. Doesn't seem to affect the image when I adjust the b&w points in ps cs2. Don't want to get too far with scanning the negs and finding out I need to go back and start again
Any advice welcomed, cheers, Carl
Bookmarks