Kodak 2D Lensboard adapter to Linhof

[ruilourosa]

Hello!!

Does anyone made or bought one of these?

I searched but nothing...

In the past i managed to make one for my kodak specialist with the original aluminium lensboard... but if i could buy one already made ...


Thanks!!!

Rui Lourosa

[Tim Meisburger]

I've always just made them. Use a thicker piece of wood so you can cut a rebate for the linhof, then cut the required rebate around the edge of the lensboard so it will fit in the 2D slot. Two short pieces of aluminum make the clamp at the bottom and sliding piece at the top to hold the linhof board (mimicking the way the 2D board is held. Worked for me.

[jim_jm]

Last year I bought a Linhof to Deardorff 8x10 adapter board from eBay seller zbima1. He might have what you're looking for.

[Roger Thoms]

Last year I bought a Linhof to Deardorff 8x10 adapter board from eBay seller zbima1. He might have what you're looking for.

That’s where I bought mine. I did a quick check and didn’t see any currently listed, so you would need to contact him.

Another source would be S.K. Grimes. https://skgrimes.com/lens-board-adapters/

Roger

[ruilourosa]

Zbima1 is not responding ... I also bought some adapters to him...

[lassethomas]

I don’t know if it’s relevant but I made and 3-D printed one for my 5x7 2D.

https://www.thingiverse.com/thing:5331403

[ruilourosa]

Thanks!!!