I haven't used this for anti-fogging before. I have some (actually quite a bit) of New Seagull VC I bought at Freestyle in 2001. It has been stored for 22 years at 37F. Printed on some of it yesterday. It looks great, until you compare an unexposed edge to new paper. Then it looks a little grey. The difference is subtle enough it is far from obvious if you don't do the side by side comparison. It is slight, but does affect highlights a little.
1. Will using Benzetriazole help with this?
2. Picker's version (going from memory here) was 2%. How many grams would it take to mix up 16 oz of 2% solution? Around 10g?
3. Is there any disadvantage to mixing up 2% vs 1%?
4. Dissolve it in hot distilled water?
Thanks.
Bookmarks