If yours happens on the expert, then its not the form the Jobo, as I use the regular Jobo, Then it must be from the holder, thats if yours is also exact same location.
If yours happens on the expert, then its not the form the Jobo, as I use the regular Jobo, Then it must be from the holder, thats if yours is also exact same location.
You are exactly right. its the only logical explanation. The line is on the film, both BW and transparencies, which means its not my Jobo. The V groove absorbs light from the shiny film, and bounces it back at 45 degrees onto he film again. I have to now sand them. what grit sand paper did you use?
again, thank you
I just used a bit of 380 grit wet/dry sandpaper I had lying around. The object is to just knock the sheen off the beveled edges of the filmholder.
It's not very invasive; give it a try and see if it solves your problem (low-hanging fruit and all that). I think what happens is that non-image-forming light gets reflected from the beveled edge of the holder onto the film making a line of denser exposure. It is somewhat subject-related and if there is a very bright area at the right place in the image, the line can be quite pronounced.
Best,
Doremus
I actually have a homemade printing easel that had the same problem. I had painted the printing frame's inside edges with a "flat" black which was not flat enough...and my solution was to reduce the thickness of these edges down to almost nothing. But Doremus...what a great idea!
Bookmarks