I remember Steve's article in View Camera magazine back in 1989 on extreme contraction. Back then it was Tri-x and very dilute HC-110. It opened doors for me regarding extreme zone techniques.
I remember Steve's article in View Camera magazine back in 1989 on extreme contraction. Back then it was Tri-x and very dilute HC-110. It opened doors for me regarding extreme zone techniques.
First, we need to clarify whether this is increased or decreased density at the top (as placed in the tank). Underdevelopment would be reduced density and contrast, while overexposure due to a light leak would be increased density, mostly noticeable in the thin shadow areas and remaining fixed relative to the notch code regardless of tank loading orientation. If you're getting increased density and contrast that stay at the top of the tank whichever way you load the film, it's *overdevelopment*, likely due to oxidation of the developer at the standing surface (pyro and pyrocat are well known for increasing stain with increased oxidation, for instance, but I've seen other developers develop more toward the surface of the developer under low agitation).
If a contact print at arm's length is too small to see, you need a bigger camera. :D
I am using a MOD54 in the Paterson tank too. I also found increased density issues however mainly at the corners where turbulence in the solution would be greatest for the MOD54. I agitate using the twirl stick provided by the Paterson, rather than inversion. I would agitate every minute for 5 seconds. I appear to have solved my problem by agitating less vigorously (slow twirl) and only for 2 seconds every 60. I do not have a densitometer so am unable to provide empirical data. I am using Delta 100 film and 1 litre of D-76 at 1:1. My prints are now acceptable.
My only thoughts on stand development in the Paterson would be that the developer would be marginally warmer at the top of the tank over time, which would provide increased developer activity and increased density.
Flickr Album: https://www.flickr.com/photos/metadi...57664271821431
When using the mod54, I usually agitate for 10 seconds every minute or 3 to 5 times per 30 seconds. I always use the swirl stick. I haven't noticed irregular development with this approach.
Bookmarks