I've acquired about half of a Cambo super, the complete front standard, the uprights for the back standard, rail, tripod block. I've done up a couple of panels for the front standard and jimmied on a 300mm lens and a Sinar shutter. Next task is to do the bellows. I'm aiming for an 8x10. Does anyone have the exact dimensons of the panel that fits into a Cambo 8x10 standard? I assume it's the same square panel with the two slots at the top that allow it to lock in, and that the bellows frame is just one of those panels with a large bellow shaped hole in it :-D

Obviously I don't have access to the entire rear standard hence the questions, but I want to make the rear bellows frame to fit anyhow in case I come across one.

Thanks,
D.