Originally Posted by
Leonard Robertson
I looked at a 4X5 Pacemaker Speed and the arm coming down (from the round shaft into the Kalart) is much closer to the camera body than yours. It is directly behind the bed support strut. The lower tip of the arm goes against the small diameter of the infinity adjusting cam. The upper end of the arm is attached to a round hub with a set screw. I assume by loosening this set screw, the hub and arm can be adjusted nearer to the camera body, which is what I think you need to do. On my camera, the upper end of the arm is about 1/8" away from the camera body.
If this makes no sense, I'll try posting a picture tomorrow.
Len
Bookmarks