Originally Posted by
polyglot
My lift handle came pre-broken and I often print in a 3063 (20x24") drum. What I do is:
- stop the rotation
- use my left hand to raise the elbow of the lift (right underneath where the cogs are) a couple centimetres
- get my right hand under the tank and hold onto the end of the lift arm as if I were using any other smaller tank
- hold the lift body/funnel down with my left hand (prevents strain on the crappy plastic lift mounting screws that I am missing one of)
- raise the arm and tank all the way up, wait for drainage to complete
- lower the arm and tank
- start the rotation again, and refill.
Bookmarks