So, my cutting head is not really running across the rails smoothly. I'd like to clean them and apply something to make it smoother. I'm assuming oil is out of the question as it will attract dust correct? What about some type of dry graphite??
So, my cutting head is not really running across the rails smoothly. I'd like to clean them and apply something to make it smoother. I'm assuming oil is out of the question as it will attract dust correct? What about some type of dry graphite??
That graphite smudge will get everywhere. Bad idea. You might need to replace the sleeve bearings, if they are still available for your model. If you do use a lubricant
you need one in which the solvent dries totally, and you obviously need to let it evaporate before you use the device. And I'd have to ask if you are using the
Rototrim for cutting down anything photosensitive like film or undexposed paper, as opposed to simply mounting tasks. A completely drying spray lube is LPS1, but
it takes at least a day or two to completely outgas. You can also find some completely drying teflon sprays, but probably not at the typical hardware store.
For applications like that I prefer a non-spray drying Teflon lubricant. My local bicycle store always has some.
Cool. Thanx team LF.
Quick practical advice advice as usual.
I was there was a forum like this for all of life's problems.
I take a sheet of baking/wax paper, the brown stuff, and cut it a few times. It does a wonderful job of ever so gently lubricating my Rotatrim. But it does sounds like yours is a little more poorly...
lol lol i am 61 ...do you have any idea how many lessons i had to learn the hard way.... i wish i was smarter....
I pick mine up by the rails all the time too. never occurred to me that I shouldn't so that....
There are "instructions" on the back that explicitly tell you not to do that. Fortunately, I read that when I got it. No, my issue is just general abrasion type resistance. I'm yet to try to fix it.
Bookmarks