Hello! I am in the process of designing and 3D printing a 4x5 camera, and I am now trying to figure out how to connect the ground glass frame to the rear standard. I have seen online different ways...
Type: Posts; User: andratos; Keyword(s):
Hello! I am in the process of designing and 3D printing a 4x5 camera, and I am now trying to figure out how to connect the ground glass frame to the rear standard. I have seen online different ways...
Thank you so much for all the effort you put in making me understand, I get it now! For some reason, I was thinking like the knob for tilt and that for rise/fall would friction on each other, but no:...
I think I understand how the rise/fall works (also confirmed by your comment). You say that “ The bolt through the interior of the cylinder controls the tilt by friction with the other side of the...
Thank you so much for all the clarifications. However I am still confused about something. Just to make sure, the system can be decomposed into these pieces: frame (it can tilt), rise-fall piece...
I do not understand from the photos if the hollow bolt with the outside thread on the left (the one with the lugs) is threaded inside or not. Is the situation the same as in my render?
Excuse me, I am not sure I understood your answers �� Has anyone addressed my question regarding the mechanism of the double knob?
Hello! I know this post is a little bit old, but I am also currently trying to make a LF camera from scratch to 3D print and I am curious about something regarding the dual knobs.
You say that you...