Originally Posted by
Gary Samson
Hello Nasser,
You should be able to successfully use Pyro PMK with HP5+ 11x14 inch film for Palladium printing. I use a 16x20 inch tray for developing. If you are processing one sheet at a time, agitate 15 to 20 seconds each minute. Hutching's Pyro book recommends 16 minutes at 70 degrees for plus 1 development of HP5+ film which is where I would start for a negative to be printed in Palladium. You can reduce development 4% for each degree of temperature increase. Another developer that I can highly recommend is Sandy King's Pyrocat M developer, a variation of Pyrocat HD.
Bookmarks