Originally Posted by
wallrat
Ok, thanks. I didn't see your reply, but I will check my spam folder :/
As for missing pieces, I knew I was missing the flash sync piece and the quick release adapter for the cable release. I was able to mount my Copal #0 just fine, the elements all seated nicely and all functions of the shutter are easily accessible, except for the shutter release of course.
Since I knew I was missing at least those 2 pieces, I wondered what else may be missing. The wire for the shutter release seems to just plug into the bottom of the cone (short part of the bend) and the long part of the bend just sits into and through the old release socket? I can thread it that way no problem, but it just seems that it should clip into the release on the board or something. It just simply lays in there. That may be correct, and if so, it seems I'm just missing the above mentioned 2 pieces. I'm on a budget so I needed to go used ($47 in excellent+ condition).
Thanks for your prompt reply and additional follow up here.
-Bill
Bookmarks