So, after many months of my life on hold, I got back to developing and scanning. Fired up the Howtek, first couple scans went well, then I started getting this error sometimes at 99% complete or just after scan starts. Doesn't matter resolution , etc.
I was scanning 8x10's
I removed and reinstalled driver and DPL. Didn't work. Never had this problem on many scans in past. My guess is the scsi card is bad. Could be cable, but not sure how that would go bad.
Scanner passes all self checks at start up and reports no error when the message appears.
Thoughts? I wonder if switching scsi I'd from 2 to another I'd would work?
I can get a new card from Aztec, etc.
Bookmarks