Hello everyone! I just bought a polyethylene batch tank to make a print washer with. My question to those of you who use a Versalab or similar type washer is about the print dividers. Are they smooth acrylic or do they have a dimpled type finish?
I ask this because I am wondering if a smooth acrylic will make the wet prints stick to them? Am I better off using a rough finish acrylic or polystyrene, like a fluorescent light diffuser, so that the print will come out easier and not stick to the sides.
Is this even a concern? I plan on Versalab/Cascade design combination.I am not totally sure on my design yet.
I would appreciate the input as far as prints sticking to Smooth Plexiglas or acrylic!
Dan
If anyone is interested you can purchase the tank that is like the one that Versalab uses from;
http://www.usplastic.com/catalog/var...ant%5Fid=6304#
Bookmarks