sooo I have this 36"x46",
and others of similar size, printed on matte vinyl (it was remarkably cheap and stunningly high quality).
I'm trying to avoid paying a lot for framing these beasts.
I've looked at making my own frames, but it's a lot of work and I don't have a workshop (although it still can be done).
I've looked at mounting on foam core (the mounted print would go on the wall without a frame), but am worried about the size of the print being a challenge.
I've also considered partial foam core mounting - just the top and bottom edge to be used as a ledge to hang the print.
Does anyone have any suggestions? I am quite handy, but like I said, I don't have a workshop and have minimal tools.
Bookmarks