Originally Posted by
joselsgil
This is a bit of advice I was given by Carol Miller of Flutot's Camera Repair.
When using a NEW cable release. File down or sand the tip of the cable release. Sometimes the NEW cable release has a very smooth round tip, which will flatten out over time, but when NEW, it can slip off the shutter's contact point, causing the shutter not to work properly. I hope this makes sense to you'll, I as try to explain this.
In my own experience, when one cable release does not work with a shutter, try another cable release. Some of my shutters only like to work with one cable release.
Jose
Bookmarks