Originally Posted by
drifty
Hi Nick...cant weigh it here I am, but its a 14x11 chasis with a bespoke rear frame, with ground glass etc, so essentially, a fraction
heavier than a 14x11. It has a rotating 14x11 reducer incorporated into a 14x17 board so will immediately accom. all reducers.
I had it made specifically as a portrait camera, so the rear frame is actually portrait rather than square.
Holders are by Sandy King out of Walnut.The are bits and pieces with it also. New to the forum so not sure about picture attachment protocol, so failing all else send me an address to forward same to.
Peter
Bookmarks