Help! I just got a used C2 Calumet roll film holder off ebay. I received it in the mail today and I was puzzled because something just did not look right. Then I realized; there's no dark slide! Is there something that i can use to fabricate one? Anyone know the dimensions? (I know I can measure, but i've never seen a complete one, so I don't know how far out it should stick)
Or am I just overlooking something? I see the slot where the darkslide should go, and I've been turning it over in my hands for twenty minutes looking for something I may have missed, but I'm stumped!
Also, does the film roll go on the top roller, looking from the backside of the holder, or does it go on the lower one? This is what I get for trying to go cheap and getting it off ebay. ^sigh^
Any help would be appreciated. Thanks a lot.
Paul
Bookmarks