I recently upgraded my enlarger to a Saunders 4550 (VCCE) which I assumed would work with my Kearsarge 301 timer as my previous enlarger did (Omega DII with a Super Chromega). I received the enlarger yesterday and upon plugging hooking it up to the timer I found that the enlarger light will not switch off in the "time" position, basically its always on. I swapped out the timer for an old Time-O-Light all-manual timer and everything works as it should. I've read that this is a possible problem with electronic timers and certain enlargers but haven't been able to figure out whether there is something I can do about it in order to be able to use my Kearsarge timer or if I'm destined to have to use something else.

Any help would be greatly appreciated.

Thanks,

Mike