Hi Stefano . . .
If the machine is completely dead, i.e. no LED's at all, then probably it is a power supply failure.
It is situated at the left hand side . . . Remove the tray protection to get access to the side cover near the on/off switch.
A replacement power supply may only be available via SCREEN . . (If you are lucky . . ) or via someone with a spare/scrap machine.
If the power supply is OK . . and the machine is an FT-S5500 . . Then I have a spare 'SCONT' board . . . (Only fits the 5500 type machine . . !!)
Hope you can work it out.
TC542
Bookmarks