I am closer to getting it done, but I still have a couple of problems.
#1. Light leak around negative carrier, It clamps down but not light tight.
#2. I have a Gralab 505 timer, it has a plug on the side for the enlarger (says enlarger). I plug the main plug from the Dichro 45 into the wall, then I plug the skinny control plug (on the left) from the Dichro 45 into the Gralab plug that says enlarger. The enlarger is on 100% of the time, it does not cycle. No matter what I do to the Gralab 505 the enlarger stays on. Any suggestions?
I do not know how to test the control plug on the Dichro.
Would it hurt the Dichro if I used the main plug to cycle the exposure, I suspect it will so I have not tried it yet.
Thanks,
Bill
Bookmarks