Has anyone replaced bellows on this unit? The rear of bellows appear to be glued to the frame. However, I've read that these are supposed to be replaceable. Mine is serial number 207. 4x5.
Has anyone replaced bellows on this unit? The rear of bellows appear to be glued to the frame. However, I've read that these are supposed to be replaceable. Mine is serial number 207. 4x5.
Yes I replaced a lot of then.
Richard T Ritter
www.lg4mat.net
Try pulling the bottom out first, Wisner put a pin in the top of the frame to keep it from falling out, allot of cameras have had this pin removed. Also the frames could of swelled and need a little force to came out. If you are not the original owner they could of been glued in by the previous owner.
Richard T Ritter
www.lg4mat.net
Hijacking of the thread; Richard my Zone VI is serial number 1987...what era does it fall in? Did you build this serial number range, or was it one of the ones someone else made.
I really like the bail you put on mine; wish I had sent it to you years ago.
Sorry for the hijack.
Mike
I have the one that referenced Vermont on the plaque on the front standard. The bellows are made so it can be swapped out with the bag bellows option. Mine comes out from the rear after removing the back. Originally was slightly stuck when I got it, but comes out easily now. Quite a neat method of attachment.
Mine is the same type...nice to switch from standard bellows to bag for wide angle lens.
Mike
Only 150 zone vi wisners were made. Serial 100 to 250
Richard T Ritter
www.lg4mat.net
Mine says #51615 but has the Newfane label. Does that mean it's an earlier one made in Japan and distributed by you? (sorry, i know this isn't the original thread)
Bookmarks