Efke 25 and Xtol: high accutance rotary processing using jobo 3010?
Xtol 1:1 with Efke 25 for 5 min rotary in jobo 3010 comes out soft and dense. How can I gain lots of accutance? Dilute xtol more and develop longer? Any suggestions? (I only have the rotary option for development at the moment).
Re: Efke 25 and Xtol: high accutance rotary processing using jobo 3010?
Excess density can degrade sharpness, and is usually a result of over exposure. Efke 25 doesn't tolerate over exposure very well. For optimum acutance you want the thinnest negative consistent with adequate shadow detail. I think this is more important than the dilution of your developer, or the method of agitation. Good luck!
Re: Efke 25 and Xtol: high accutance rotary processing using jobo 3010?
I've used Efke 25 and xtol 1+1 quite often and it yields a very sharp negative. If high acutance is what you are after, then try something like Rodinol.
Bookmarks