Hey there guys! Hopefully this isn't OT, but just wanted to say that after a long day of first attempting the carbon transfer process, I have considerably more respect for those here on the forums that regularly print this way. Though I mainly spent the day getting myself acquainted with the process, practicing the techniques, and making a few test strips, I'm starting to realize this is a deep, deep hole to get into.
Now onto the Q&A:
1. The minimum temp I'm getting from my darkroom sinks is 72 degrees Fahrenheit. When pre-soaking my final support (single transfer), should I adjust the recommended 15 min time? How about with the 1.5 min tissue soak prior to transfer?
2. What's the best way to get rid of excess grey streaks of tissue after warm water development?
Big thanks in advance for your input, I hope to have some decent images to show this forum by Christmas. ^__^
Bookmarks