Hi All,
I seem to have gotten better results with the streaking issues in the JOBO with 810 porta. I stopped doing any sort of presoak and it seemed to help.
The photo below is porta 160NC @ 120. Fresh tetenal mix, pre heated tank, solid temp of 104', JOBO 2830 tank on a bessler reversing roller base. I had another sheet in the same tank with this and it came out perfect.
There is a slight streak in the sky but the real issue is the color cast on the upper RHS of the photo. This seems to go all the way into the rebate with the rebate being a deep magenta then fading into black. The area affected was at the top of the tank.
There was a slight bit of vingetting on the top RHS as well. I slightly cropped it to get rid of the worst of it.
Any thoughts?
I love the 810 C41 prints and hope to contact print them eventually. I now use a color meter and try to fix the colores on the negative to get a leg up on the contact prints once I get to that point. I am a bit frustrated that I seem to have so many issues with color/810 and doing the developing at home. Any help will be appreciated
0611 4 810 CLR.jpg by
urbanlandcruiser, on Flickr
Bookmarks