Thanks for your input guys! Will look into it and try to correct the errors later on.
Thanks for your input guys! Will look into it and try to correct the errors later on.
Thanks, I’m happy if this helps people building interesting things! It was fun to do this too.
Also, thanks for pointing out the errors. I think I fixed the translocated and incorrect values. Will do a doublecheck later on.
As for the T-inconsistencies for 11×14 and 14×17 — what should be the right values? In the ANSI there is also a table with imperial conversions. Those are identical.
There are some other areas that look suspicious. For example: Why are only negative tolerances allowed for some of the M1/2 values? Should M2 really be 1.57 on 4×5 holders?
There is some discussion about 14×17 holders in this thread, with some actual holder builders taking part.
Considering the allowed tolerances for »T« with 14×17 holder add up to slightly more than 4/5ths of a mm, the values mentioned seem to be well within these.
Not sure about ULF, but with 8×10 holders Intrepid is not able to keep up with the demand. I’ve ordered one about 4 months ago, still waiting for it. I think most people who try to build their own holders are mostly not the same ones buying professional holders.
Bookmarks