I recently bought one of these new from the manufacturer in Michigan and wanted to write some positive comments. I was looking for an 11x14 washer. I bought two used. The first was a Salthill which I assumed would be fabulous but one little piece of acrylic was broken and I just did not like it. I actually gave it away to a guy who is handy and he was able to fix the acrylic. He got a good deal. Then I bought a used Inglis washer. I already have an Inglis 8x10 film washer which is excellent. The print washer was also excellent. Inglis is high quality gear. But my version had only 6 slots and they were not large enough to accommodate 2 8x10's so I found it limiting. My other washer is a 20x24 Summitek which is good but it makes an awful sucking noise that is so loud I don't like being in the same room. Also, it is often overkill for washing 8x10's and 11x14's.
Anyway, I decided to buy a new washer. The larger sized 11x14 Inglis is pretty expensive so I tried the Rosy which is apparently identical to Arkay (they make Arkay I am told). It cost me about $300 including shipping so it wasn't cheap. But it is built like a tank and very functional. It is a stainless steel tank with a plastic insert for dividing the prints. The insert has an additional rod that can be used to force the separation of 2 8x10's in each slot so I can wash 20 8x10's in a compact washer. The footprint is significantly smaller than an acrylic washer. It must be used "in sink" unless you are creative. It comes with a washer hose and clamp that attaches to a stainless steel nipple at the bottom of the tank. I used the supplied clamp along with 3/8" ID vinyl tubing. Water exits 3 holes at the top of the water which makes it easy to level by visual inspection by looking at the meniscus at each drainage hole. It also has a small hole at the bottom which drains the bottom continuously. That is my only complaint because you can't leave it sitting there full of water. I cover it with tyvek tape which works OK but I might get some type of plug.
It works really well. It operates quietly. It is fairly efficient with water but not so much as the Summitek. The prints are easy to put in and take out - much easier than the 20x24 washer. He makes a custom crate for shipping which is impressive by itself. I saved mine. No way it could be damaged in shipping.
Not many darkroom gadgets of any sort still being made, especially in the USA, so I wanted to give very positive review for anyone considering buying a new print washer.
http://www.rosyproducts.com/archivalprintwashers.htm
Bookmarks