I bought a miniature speed Graphic, which takes 2 1/4" x 3 1/4 film and I bought some Efke 100 2 1/4" x 3 1/4" film. I also bought some sheet film holders, off eBay.
The thinner ones that hold one sheet actually say it is for 2 1/2" x 3 1/2". Could this also be used for 2 1/4" film? If I stick the holder in, it seems to stick out a wee bit. Is this normal? I attached a photo with the holder inserted.
I also got the thicker sheet film holders that hold two sheets and they say it's for 2 1/4" x 3 1/4" sheet film. However, it's so thick it seems like it going to break the metal piece if i try to pull it back far enough to fit it in?
What am I doing right and/or wrong?
(I've used Leicas and Rollei so I'm not too dull when it comes to mechanical cameras, but this is my first foray into sheet film cameras. I'd like to eventually get a 4x5 crown graphic.)
Bookmarks