Neil, How tall are the dividers? I tried a divider arrangement before the pegs. The dividers were only about 3/8 inch tall. I thought by keeping them short I would avoid flow turbulence. The problem was the sheets would float over the dividers. That's why I tried the posts which are a few inches tall. I put two posts on each of the four edges of the film to keep the film in position.
The dividers are 1 1/4 inches tall. Also, I cut a diagonal about 3/4" long off each corner so that the slosher can fit in my 8x10 tray that has rounded corners. This not only allows the slosher to fit in a rounded corner tray, it also facilitates picking up that corner of the film if one wants to develop each film for a different amound of time.
Yeah, I was wondering about that. Actually, I've alloted a little extra space in the center of my slosher for a Zone VI compensating time temperature probe. I was hoping that this might adjust for the variability in temperature that I thought might result from tray development. I wouldn't even consider tray development without a device like this.
Posting Permissions
Reply With Quote
Bookmarks