Bob, I haven't noticed the light table going out. I don't keep the lid open for long though so I am not sure. The light table is kind of useful to spot those dust specks that I missed when putting the neg in the resin holder. Maybe you need to replace the lamp illuminating the light table? It looks like my light table goes on when I open the lid. Or could it be a bad micro contact? I had a look in the hardware manual but I cannot find anything about the light table and what kind of lamp is underneath it. As far as can tell the light table is not illuminated by the reflective scanning lamps.
Peter, doesn't a higher optical resolution give you a higher enlargement factor? If I for instance scan at 4300dpi instead of 4000dpi I can print a little bigger if using a set printing resolution like 300dpi. Even if the extra pixels from scanning at 4300dpi don't yield any extra real information they are still there and will enable me to print larger?
Chris
Bookmarks