Greetings all,
New member here; and first posting. This will probably come across as eye-rolling dumb; but I must ask as I am new to the lens and board combination. I have a Rodenstock 150mm with a Copal 0 shutter and bore. I am attempting to mount it on a Sinar lens board. However, the lens ring appears too small for the board as it will actually fall through if I try to tighten it. That’s the first issue. The second issue is when I get the lens tight enough to barely hold it onto the board, the aperture adjustment won’t move. Am I missing a part(s) here? I’m thinking the board was machined for a lens other than Copal 0; but I’m concerned about the aperture adjustment.
Please help me out as I am off to a fairly rough start here. Any suggestions are not only welcome but desperately needed!
Jeff
Bookmarks