Hello faith, I have just replied to your email but il mention this quickly on here too for any other Compact Enlarger users
There are four dome head screws on the light source part of the enlarger, they are attached to the mounting bracket that has the 1/4 thread cut into it. you can loosen these off slightly and it allows you to adjust the rear of the enlarger back into parallel. This will have been set in the workshop but it might have been knocked during transport or potentially an error on our side by not tightening them down enough after testing. Either way sorry that it didn't arrive spot on! you will need a 2mm allen key to adjust these screws and it should sort the problem out. also please make sure the two thumb nuts on the light source are tight when measuring for parallel,
- Best, Max
Bookmarks