Bob, I was considering making a water wall inspired in dust collection systems:
https://www.youtube.com/watch?v=gwEXuktc2tw
It would be an inclinated board (in the water wall is vertical) with something collecting water at the bottom, and a pump recirculating the liquid to the top.
This would take developer one shot, the water stop, the fixer one shot and washing water (dumped and refilled several times).
I'm considering to place that inside a ULF Jumper 2 L2H2 van I'm projecting, I've the van yet, but it should also work in a darkroom, in that case water could be continuously replaced.
The challenge is to adhere the print to the wall, I was considering placing suction ports in the top of the wall (several areas with perforated plating) and using a vacuum pump.
Bookmarks