Formalized the Intrepid extension a little bit today by doing a 3D print and getting a nice knurled screw.
Attachment 222636 Attachment 222637
Did a flange to film measurement and got it to about 47mm. Little enough for any 4x5 lens I know about.
Movements are of course very limited since the bellow is very compressed. And there would be problems in portrait mode getting the rail in the picture, at least with a super wide.
But it works, and if you don't use a lot of fall on the front standard you can keep it on all the time.
This is the screw I got:
https://www.ebay.com/itm/164981595450?var=464521777930
Anyone who want to print themself can pm me for the stl file.
Bookmarks