A quick update: I replaced the wheels yesterday. The ones I bought from McMaster-Carr (https://www.mcmaster.com/2337T22) fit fine and were a very similar hardness to the orginals, but didn’t rotate well when the bolts were tightened down. I replaced the bolt and added a locking nut, and now seems to rotate fine. I am not sure about the permanence of the nylon locking nut.
I am still struggling a bit with the leveling feet. The thread is 5/8" with 11tpi, and the whole thing is about 6.5" long. To replace all four with knobs isn't cheap, so it will likely be the last thing I do. Next week might be cutting time!
The club sounds good!
Bookmarks