Hello all.
I've tried searching the forum to find solutions to my problem, but my search turned up 164 pages of results, none of which I have found a solution.
I have a JOBO CPP2 processor. All things work on it aside from the motor. It worked up until a little while back. I put on a 2000-series tank with fluid in it, it spun a few times and then stopped completely.
I read through manuals and repair guides and decided I should have a look at fuses... I opened up the unit and found the motor fuse blown. I changed the fuse, plugged it in and the fuse blew instantly.
I called Catlabs and someone over there said it could be the two motor "DC regulators" on the board. I'm forgetting if they said "DC regulators" or "DC" something else. I could not find any reference to any "DC" motor... in the manual or repair guide.
Have any of you had an issue like this? If so, did you figure it out? I've heard folks say to hook the motor up to an power supply to test it out, but I wouldn't know how to do so safely. Any thoughts?
Curiously,
Jim